Perlite, production of perlite aggregate for insulation , filtration and horticultural
Perlite - rotary precoat filters
Relatively thick precoats, 50-150 mm, are used on rotary drum filters.
The precoat is formed on a drum covered with cloth or metal septum by pumping a slurry of clean liquid with 2 to 5% filteraid to the filter and returning the liquid precoat tank. The septum should be kept clean, as a dirty septum can be source of troble in causing cake craking, nonuniform precoat thickness, cake falling off and low flowrates. Depending upon the filteraids permeability, the vacuum capacity of the filter and the filter drum rotation rate, a 50-100 mm precoat can be applied in ½ to 2 hours. Too rapid precoating rate and too high filteraid concentration in the slurry can cause excessive cake shrinkage and cracking although small hairline cracks are normal.
During the operating cycle, passage of the process liquid through the precoat leaves the filterable solids in a relatively thin film which just penetrates the precoat surface.
A mechanically operated knife blade continuosly shaves off the filterable solids and leaves a clean fresh filtering surface. The knife is usually set to cut between 25 and 250 microns deep. Selection of the proper depth of cut depends mostly on the nature and quantity of the filterable solids, and the degree of penetration into the cake.
The most economical drum speed is determined largely from the characteristics of the filterable solids. As a general rule, the slowest drum speed compatible with productions requirements is recomended. Speeds commonly range from 1 to 1/5th revolution per minute.
For any given operation the flowrate in l/m²/hour depends on the knife cut, drum speed, grade and type of filteraid used, the filtration resistance of the suspended solids, and the viscosity of the process liquid. Flowrate is dictated by production requirements, thus the drum speed and the cake knife cut must be regulated to give needed throughput. This may result in higher filteraid consumption, but may be justified by peak demands, lack of suffient filter capacity, or a temporary run of hard-filtering liquor. Another way to increase flowrate (again at the expense of filteraid economy) is to add filteraid to the charge liquor. On a long term basis the purchase of additional filter equipment proves most economical.
Selection of the best grade and type of filteraid is based upon determining the one which will minimize penetration of the suspended solids into the precoat cake so as to make possible the thinnest cuts to maintain desired flow.
Three outstanding advantages of Perlite filteraids are:
- economy because of high volume-to-weight ratio
- high efficiency in filtering high solids contents liquids
- excllent resistance of the filteraid cake to cracking.
